Before you run or operate your nitro RC cars make sure that you follow good practices and steps.
This will ensure that your remote control cars remain in excellent shape and condition out from the box till their lifetime use.
1. Check if the receiver battery is in order.
2. Be sure to install radio batteries correctly.
3. Do a range check from a distance to see if the RC car is responding properly to the control.
4. Make sure the glow plug is tight and the glow starter is charged fully.
5. Ensure that the flywheel of the engine is tight.
6. Tighten nuts, bolts or screws securely.
7. Check the nylon ties, the clutch-bell & spur gear mesh, and the pull-start engine screws as well
8. Ensure the servo & throttle linkage are at 90°. It should be in proper alignment once the radio equipment is on. Make necessary adjustments when needed.
9. Make sure the fuel system is free of any obstruction, or line pinches or leaks.
10. Clean, re-oil or replace the foam air filter when needed.
11. Be sure to clean the RC car before & after every run for dirt, sand, mud or rocks to ensure proper and correct operation, as well as avoid any damage to the RC car.
These are the eleven steps to keep in mind always safeguarding and ensuring proper care and maintenance of your nitro-powered or petrol RC cars. Follow them religiously to prolong the car and enjoy more running time in the tracks.
Hope that you that this simple guide can help you. Visit us next time for more helpful tips and advice.
Thank you for reading article.